@noiasca wrote:
I want to share a part: It is a
DOIT ESP32 DEVKIT V1
with 30 pins. The pins are (obvious) in two rows and the distance between the two rows is 1100 mil. The pads are oblong/rectangular - so it is able to route between pads.
I did a gerber export and let seedstudio produce testboards. The pads, the holes the routing between the pads look all ok. There might be issues with the breadboard view - I’m sorry for that, but I’m not using it. But schematic and PCB should be ok (at least as I found out so far).
DOIT Esp32 DevKit v1 (30 pins long, 11 pins width).fzpz (24.6 KB)
Posts: 2
Participants: 2