Hello,
my problem is, that I have found a part which looks kind of the same what I am searching for. But the connectors on the vertical axis are one pin too close to each other.
I would need the lower connectors to be at the red line:
I’ve tried to work it our with tutorials, but got grounded pretty hard. Would be really great if someone could help.
Previous work, similar parts
4 x 5V to 3.3V logic level converter
Top view
As a new user I am only allowed to upload one graphic. This one can be found in the datasheet.
Datasheet
The official documentation of the part manufacture is linked here:
Type
I did not read this
Breakout board, sub assembly, plug in module (A)
Antenna (AE)
Battery (BT)
Capacitor (C)
Diode (D)
Display (DS)
Fuse (F)
Hardware , mounting screws, etc. (H)
Jack, fixed part of a connector pair, header (J)
Relay (K)
Inductor, Coil, Ferrite bead (L)
Loudspeaker, Buzzer (LS)
Motor (M)
Microphone (MK)
Plug, moveable part of a connector pair (P)
Transistor (Q)
Resistor (R)
Thermistor (RT)
Varistor (RV)
Switch (S)
Transformer (T)
Integrated Circuit (IC)
Crystal, Oscillator (Y)
Zender diode (Z)
Other (please specifiy)
Footprint
ST1167
1 post - 1 participant