Good afternoon. I am fairly new to Fritzing and have struggled to find the correct part that I am looking for. I am trying to make a replacement cable housing for my laser engraver cable.
It has JST connectors on it - but these are 2mm pitch rather than the standard 2.54mm pitch.
I am looking for fritzing parts for the top loader Make and Female parts.
I am looking to make a small PCB so the parts need to work on the boards.
B6B-PH-KL
JST PH - 6 pin Male
JST PH - 6 pin Female
A datasheet link → https://www.sparkfun.com/datasheets/Prototyping/ePH.pdf
I’ve tried a lot of the JST parts but they do not go up to 6, nor are the right package type.
Also - how do I set the breadboard to 2mm pitch ?
Would appreciate any assistance if possible.
Kind regards
Strav
1 post - 1 participant