these are the 3.5mm jacks commonly used for DIY synths. there’s a part attached in this topic for the older version PJ301M-12, but the breadboard view isn’t actually correct, the spacing of the legs is off, and it’s difficult to use because it’s a side view. i used that file as a starting point; my version is drawn top-down, with correct spacing for the legs:
Thonkiconn PJ398SM.fzpz (6.1 KB)
this is my first custom part! hopefully all the metadata and stuff is correct, it’s kinda tricky to get this stuff right
1 post - 1 participant