Schematic & PCB Help

Hi Everyone,

New here and new to fritzing (why I am in the beginners section :)).

I have done a breadboard design (I have actually soldered this onto a blank PCB and built the software already so I know it works) but I am looking to get a ‘real’ PCB done (outsourced) so looking to sort out the schematic and PCB.

After I built my breadboard I went into schematic and it is truely a rats nest and I can’t figure out how to lay it out nicely LOL. The same for PCB :(.

Any help, ideas, suggestions would be greatly appreciated.

Thanks in advance.
C

multi_sensor.fzz (38.0 KB)

1 post - 1 participant

Read full topic