Hi,
I have built my first schematic in Fritzing. Many of the connections terminate at GND.
In Breadboard view, I want to set the columns on either side of the many rows as as +V, -V and GND.
Does Fritzing understand that I can make many common connections to a breadboard column? If so, what is the neatest way to achieve this, so that components going to ground only connect to that column, and not to each other?
When I make a GND connection from a component to a column, to make that column represent GND, the component I’ve connected also connects a wire to another component which has a connection to GND. I want the components to connect to the column, but not to each other.
I hope it makes sense - thanks!
2 posts - 1 participant