@gpcullip wrote:
Hi Peter
As I am getting into part creation a little more each day whilst learning a great deal, I find myself looking for at the Frizing core part variables and designations like connector#terminal, connector#pin, terminalid, svgid with the various files.
If find myself asking the same questions over and over:
- “Are the more variables and designations I should be aware of?”
- “Is there a list of all of these variables and designations somewhere?”
As your aware I’m not a software engineer by any stretch (my terminology may be a little rusty), but I have dabbled in the past with various languages so the syntax’s are familiar enough I can navigate and make sense of them.
Kind regards
Glenn
Posts: 1
Participants: 1