@BusDev wrote:
Hello,
I am a newbie, and have created a rather simple circuit. Just powers a wemos mini d1 board, and then reads accelerometer data on I2C.
I want to keep the PCB size as small as possible. Reason, is this will be mounted in a cyclindrical pipe body, so best to be small.
Also, i plan to have a HEADER [male pins and female recep]. I want to solder this header to my custom PCB board. Then solder the accelrometer to PCB board.
Then i will press mount the Wemos [which will have male pins] on top of the Header’s female recep.
My question is: Does my PCB have all holes for the female header suitable for Wemos ? I cannot say, how many holes will i see once i order this.
I am expecting [or want] a total of 16 + 8 = 24 holes in my PCB. and 4 mounting holes on the corners.Is there a software or tool, that tell me how my PCB will look like before i order it ?
I will be glad if someone took a shot at optimising this PCB based on best practices.
Thanks in advance.Regards,MMA8451_WemosDIMiniPro_MaleBelow.fzz (42.6 KB)
Posts: 2
Participants: 2